Quantcast
Channel: tcpmeta – The IT Garage
Viewing all articles
Browse latest Browse all 115

3D Printer station Part 2

$
0
0

Finished for the most part. I shortened the tool board and attached it to the rack and on the backside I added the power supplies. For the power supplies I wired them up together to a single power cable. If I ever need to run one printer I’ll just use the quick disconnect.

Old build plates to protect the PEI build plates.

All whats left is to get power to it. I decided for when I do that outlet I will have a light switch inline to turn the outlet ON/OFF.


Viewing all articles
Browse latest Browse all 115

Trending Articles